This table lists host information pre-configured in CML/VIRL, information that might not be required by the lab but may be useful to you. This table lists the interfaces used in the lab exercise documentation that differ from those used in the sample CML file. The switches used for this lab are all layer 2 switches. Test the configuration using some of the suggestions below.Add your planned configuration to the lab.Compare the lab topology and interface IDs to this lab, as they may differ (more detail below).Import the lab’s CML file into CML and then start the lab.If you prefer to use CML, use a similar workflow as you would use if using Cisco Packet Tracer, as follows: CML-P (or simply CML) replaced Cisco Virtual Internet Routing Lab (VIRL) software in 2020, in effect serving as VIRL Version 2. You can also implement the lab using Cisco Modeling Labs – Personal (CML-P). 200-301 V2 Ch16: Controller-Based Networks.200-301 V2 Part 4: Network Architectures.200-301 V2 Ch12: Miscellaneous IP Services.200-301 V2 Ch05: Securing Network Devices.200-301 V2 Ch04: Security Architectures.200-301 V1 Ch25: Configure IPv6 Routing.200-301 V1 Ch24: Configure IPv6 Addressing.200-301 V1 Ch18: Troubleshooting Routing.200-301 V1 Ch16: Router Addresses and Routes.200-301 V1 Ch14: Analyzing IPv4 Subnets. 200-301 V1 Ch12: Classful IPv4 Networks.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |